Chase Research IOPRINT+ Print Server Guía de usuario descargar pdf (Pagina 210)

IOPRINT+ Print Servers

Configuration options

Page 210

Configuration options

These options allow you to configure the current IOPRINT+ Print Server.

Option Details

System Allows you to change the device name, and to set the LAN

protocol(s) used by the current device. Only the Connected Protocol

referred to on page 64, and your LAN protocol, should be enabled.

Note that by default, all protocols are enabled. This allows operation

in any environment, but degrades performance.

Netware Configure NetWare with this icon.

TCP/IP Use Settings -IP Addresses to initially assign an IP address, and this

button for any subsequent changes.

AppleTalk Enter AppleTalk configuration details here.

NetBEUI Allows NetBEUI (Windows SMB) changes to be made. The available

fields are as follows:

Domain name Enter the designated work group to be serviced by the IOPRINT+

Print Server. Using only UPPER CASE is recommended.

Response Time Sets how fast jobs are sent to the printer. The default value of zero (0)

delay should be increased only if your printer cannot cope with no

delay.

Abort Job As

Paper Out

YES will terminate the current print job when a printing error is

encountered. NO (default) will try to continue but may cause print

errors. If errors occur, try setting this value to YES.

Note

Normally, there should be no need to adjust these settings.

Serial Port Configure the serial port if one is fitted. Check your serial printer to

see what settings should be used.

Logical Port Logical ports (printers) can be used under NetWare or Unix.

SNMP Enter SNMP configuration data here.

1 2 ... 205 206 207 208 209 210 211 212 213 214 215 ... 304 305

Sin comentarios

Chase Research IOPRINT+ Print Server Guía de usuario Pagina 210